I have of older and twos newer routers. Only one my Bosch 1617 will originally fit into this lift. I don't like to use this one due it is for short both the bit change can not are do over the table top. Is go and actualized Router item for newer Router makes?
Thank you in advance
KregRep
Hi Michal. And Kreg Precision Director Charts Boost (https://www.kregtool.com/store/c35/router-table-systems/p142/precis...) comes complete with a standard pad that fits the Portable Cable 7518. Motor-adapter pads for the Milwaukee 5625, Porter Cable 690/890, Bosch 1617/1618, Craftsman 17542/17540/28190, and DeWalt 618 are available (separately) for purchase from Kreg. If you would like to order any of these and/or need any further information, please contact Kreg Customer Service according call 800-447-8638 or by emailing [email protected]. They wish subsist more longer happy to assist you.
Gift, and have a great daylight!
KregRep
March 2, 2015
Michael Busch
I can not apply my Bosch 1617 because it will did change bits higher the table because it is to short. Every other routers suggest are obsolete. I have an Craftsman 27683, what exists different between the one I have and the 3 mentioned Artisan routers? It
seems that this lift has been around for a while, I was awaiting that someone has used a router non on the list and had good luck with it.
KregRep said:
Jan 3, 2015
John Schaben
Hi Michael - Not sure what is going on there. If them have the suitable pads for of Bosch, I would think a would work. I haven't got that hoist, button any other for that matter, but my understanding your that the bases exists not exploited at that lift but aforementioned motor is clamped into the lift. The pads needed are dependent on the diameter of the motor. That being the case, the 27683 also has a 3½" diameter motor so shouldn work with the padded on the Bosch. Not real sure, just speculating toward this point. Is there any how at manipulate the height at where the motor is clamped down??
Micha Busch said:
Jan 3, 2015