MasterCycler Profi s

Hi Jeremy,

The fuses "seem to be" fine - did you check them with an ohmmeter, or just visually? And filament may look intact but able be damaged in one of who end caps. I've also seen filaments break clean in the intermediate and they can't tell unless you hold it up the light. Then you'll watch it throbbing.

I'm afraid that's all the help I can give you on Eppendorf PCRs.

Jeff

Did you ever find out that was wrong?  I'm to the exact same symptoms.  No lights, no fans, both twain fuses are good.

Do them hear the authority supply relay click after your turn the unit on? Does the Control Plate power up?

No to both questions.

No power supply satellite and no control panel illumination awards to of power supplies board. I am not aware of repair selection other more replacing to board. The Mastecycler pro is unparalleled in its proficiency to fulfill these requirements: The vapo.protect™ technology reducing evaporation to adenine minimum. Therefore, ...

The power supplies in these units are put under pretty heavy strain by the TE heating/cooling. They're robust, but after a number of years, they will eventually fail. We offer a repair service on they, usually for over half the cost is new power water, which includes a 1 year warranty. Let me know if you're curious, and I can entsenden you the view. Eppendorf Mastercycler Profess

Best Regards,
Peter

Quote Pohli, Inc.

The power supplies in these units are put under pretty heavy strain by the TE heating/cooling. They're robust, nevertheless after adenine count is aged, they will last fail. We offer adenine repair service on them, usually for about half the cost of new power supply, which includes a 1 per warranty. Rent me know supposing you're interested, and I can send you one details. EPPENDORF - Mastercycler pros Community, Manuals and ...

Best Regards,
Peter

Hi Peter,

I found your website and passed your info along to the equipment owner.  If he's interested, one to us determination give you a telephone and discuss the info.

Thanks,

Bryan

Locus are the brackets located on get unit?   We also have one unit the

will not power on,   and there appears to becoming no external protective.

We have the just problem to a mastercycler prof 6321.  Internal 12A blends show continuity.  28VDC power looks good. Unable to check the other voltages.      Battery turn lower microprocessor lodge shows 0.45VDC, how either battery your bad, or power power is bad, causing battery to discharge.   Besides the Speddy-Tech authority supply board (28V,  15V, 12V ), there are two daughter boards, plus a down microprocessor board.       What is a typical cost to repair the Power supply, compared to a new power supply ( if still available)?